Measure and plan the position of the holes so that the bolts are secured into the brickwork and not the mortar. Check that they don't coincide with the eventual positions of the joist hangers. Make sure that they are not too close to the edges, or else they will weaken the joist. Arrange the holes alternately at the top and bottom. Step 1ĭrill holes at 400mm intervals along the length of the joist being fixed to the wall. The rest of the decking's sub-frame is then aligned with it.īefore starting, check that you won't be blocking off any air bricks or interfering with the damp-proof course (DPC) by attaching the joist. You can skip this section if your decking is not being fixed to a wall. This stage involves fixing one joist directly to the wall. Decorator gloves - for applying the end grain protector.As for instance, ear defenders worn over goggles may create a gap which lets the sound in - therefore we recommend ear plugs. Dust mask - look for ones that are suitable when cutting timber.Rigger gloves - for handling the timber.Start clips and hidden fasteners set - only needed as separate purchase if solid composite deck boards are bought in-store.Solid composite deck boards - includes start clips and fasteners when purchased online.Coach screws - 6 or 8mm in diameter, with the length dependent on what's being secured.Paving slabs or block paving - for a secure footing.Hand plane or electric planer - if necessary.And if laying Grassedeck boards, opt for green-coated decking screws to minimise the appearance of the screw heads. Decking screws - we recommend choosing screws that are at least 2.5 times longer than the surface they'll be secured to (the deck boards).Paint brush - to apply the end grain protector.Circular saw - for cutting lots of thick timber, if necessary. Jigsaw - for making fiddly cuts in timber, if necessary.Finer-toothed saws offer a neater finish, but take longer to cut with. Panel saw - for a small project or cutting a few very thick pieces of timber, if necessary. Coach bolts - 8 or 10mm x length required for joining joists together, if needed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |